Originally posted by siman
View Post
Note that code entry is only possible when a number is flashing in the seperate display.
If the display continually shows "CODE" then the unit may be codelocked and will need
to be left switched on up for up to two hours to reset before another code entry attempt is possible.
If it does not reset after this time, then all of your code entry attempts may have been used up,
and the unit will need to be sent to expert service to be decoded and reset.
Code Entry as Follows:
Switch Radio On - Display Shows " CODE "
Then " 0000 " with the 1st digit flashing
Rotate " Thumbwheel " For Correct Digit
Press " ¬ " On The Stalk Control To Enter
Rotate " Thumbwheel " For Correct Digit
Press " ¬ " On The Stalk Control To Enter
Rotate " Thumbwheel " For Correct Digit
Press " ¬ " On The Stalk Control To Enter
Rotate " Thumbwheel " For Correct Digit
If the correct code number is now shown
Press And Hold " ¬ " Until A Beep Is Heard
Without steering control:
Press preset 1 repeatdly for the first number
Press preset 2 repeatdly for the second number
Press preset 3 repeatdly for the third number
Press preset 4 repeatdly for the fourth number
Press and hold preset 6 for 10 seconds to store code, note, some radio model uses preset 5...
Comment