Motorola v3...I can't unlock it with Rocker Dongle..WHY? please help me!

Hello, I need help to unlock a Motorola V3

Bootloader 0A.52
Firmware R4515_G_08.BD.E1R

using Rocker Dongle device...please...give me some help ASAP. All this is without TP or not?

Thanks in advance

Please, answer me ASAP.

AKS_KADHAR wrote:

Hello, I need help to unlock a Motorola V3

Bootloader 0A.52
Firmware R4515_G_08.BD.E1R

using Rocker Dongle device...please...give me some help ASAP. All this is without TP or not?

Thanks in advance

Please, answer me ASAP.

See attachment....boot 0A.52 need TP, but you can do the following:

Do TP, click REPAIR, this downgrades boot to version 0A.30 so you can operate phone as usual, unlock without TP, repair IMEI, or even flash it without any problems.

Regards.-

But where I get the picture to do TP? for this model? please help me....

bogoss_abv_bg wrote:

But where I get the picture to do TP? for this model? please help me....

From support ofcourse :ihih:

So? it worked or not? :confused5:

Get this error "Access denied. Try to boot with testpoint" with test point

Manitou wrote:

Get this error "Access denied. Try to boot with testpoint" with test point

Wrong testpoint procedure, check good contact with testpoint and ground, and procedure too, you must connect testpoint before give power to pcb, when it is detected as S FLash then release tespoint.

Maybe try another testpoint also, check correct V3 model.

Regards.-

i use smart TP and work another v3 probably this have a problem, i make by code :|

gsm_masud7 wrote:

i use smart TP and work another v3 probably this have a problem, i make by code :|

Then you go ahead and throw your dongle in the trash if you can't figure it out. V3, V3r and V3i's have been supported for so long with or without testpoint.

gsm_masud7 wrote:

i use smart TP and work another v3 probably this have a problem, i make by code :|

You're not being specific about your problem....Boot loader Version? SW Version? V3 Model??

You should also start a new thread, and like vermsky said, V3 it's supported long ago, so as much info you give it would be more easy to help you and faster also...

Regards.-

you just connect tp when software say to LTE 2 etc is connected then disconnect the tp unlock the phone, it is maximum 3 or 4 sec method. It is very simple method.